Q: For installing a deck ledger, structural screws such as LedgerLoks (which don't require pre-drilling) are so much easier to use than the lag screws and 

I think the answer to this will be "it depends" since there are different size lag bolts, there's the number of bolts you intend to install 

also called lag bolts, lag screws are generally used to connect heavy lumber and other materials that bear an intense load when you are fixing the newel posts, using timber locks or ledger locks would be a better option than using screws and bolts ter 1711-01 rev 10-29- deck ledger attachment using spax powerlags (1 mb) spax technical

The lag screws or bolts in deck ledgers and band joists shall be placed in accordance with Table R507.2.1 and Figures R507.2.1 (1) and R507.2.1 (2). Lag screws or bolts shall be staggered from the top to the bottom along the horizontal run of the deck ledger in accordance with Figure R507.2.1 (1). Maximum 5 inches.

Search: Ledger Locks Vs Lag Bolts. On the one side are the "warmistas," with fixed views about apocalyptic man-made global warming; at the other extreme are the "deniers Structural Screws Model #FMLL00550 The labor difference is so huge that by the time you finish drilling pilot holes and ratcheting in just a few lags, you could have finished the whole job Lag bolts come in different

Recently had the dreaded second opinion saying our 4 inch 3/8 lag screws should be 6 inch. See if your inspector will buy ledger locks.

Use Case. Both screws are designed to replace lag screws but they still do different jobs. LedgerLOK is better for attaching heavy decks to wooden house structures. TimberLOK on the other hand is better for attaching raptures or trusses to a different structure (think fences). LedgerLOK screws are designed to replace lag screws and through-bolts.

Search: Ledger Locks Vs Lag Bolts. Using LedgerLoks or lag bolts that are 1/2" longer than all of that are all that code requires, and that is going to give you the second strongest attachment possible Coating Lag Screw It will sink them in mode 2, but mode 3 is super fast, burying the screws in about five seconds There are also a few other differences between lag screws and wood screws This

10/30 · Lag bolts, on the other hand, have a hexagonal head that requires socket wrench for fastening. Because they are quite thick, they require a pilot hole to be pre-drilled. As such,

PDF Hexagon Head Bolts Din 931 933 Central Engineering. ISO 4014 Bolts, ISO 4014 Hex Head Bolts and Hex Bolts Material DIN 603 Carriage Bolts; DIN 479-8.8 Square over M24 or nominal lengths over 10 d or 150 mm, whichever is the shorter. Page 4/5. Hex Bolts - Westfield Fasteners Ltd Tight-Spot Hex Head Screws A high -strength alternative to blind

They manufacture a full line of bolts designed for many applications of which is especially for attaching decks to homes. The and IRC (International residential Code) section R502.2.2.1 requires galvanized lag screws or bolts. LedgerLok bolts meet the above criteria and were approved under ICC Acceptance Criteria AC233 (ESR #1078).