A tolerance of ±5º is acceptable but it is a matter of luck whether this will be achieved when first screwed in because the eyebolt manufacturer has no control over the start point of the threaded hole. Therefore it is permissible to shim up to half the screw pitch to achieve the correct orientation.

Use a spreader bar with regular (non-shoulder) eye bolts to keep the lift angle at 90° to the horizontal. Use eye bolts at a horizontal angle greater than 45°. Sling strength at 45° is 71% of vertical sling capacity. Eye bolt strength at 45° horizontal angle drops down to 30% of vertical lifting capacity. Use a swivel hoist ring for angled

Material: As specified by BS 4278 Hardened and Tempered S.W.L. Shown at 0° (vertical) angle of lift. Safety Note: Eyebolts under M12 are not recommended for lifting. Non-standard thread pitches available upon request. Various sizes from M6 to M80. Capacities (SWL - Safe working Load) from 100kg up to 30t. Self-coloured finish as standard.

All bolts threaded UNC. • Forged Steel - Quenched & Tempered. • Working Load Limits shown are for in-line pull. For angle loading, see page 196. • Meets or exceeds all requirements of ASME B30.26 including identification, ductility, design factor, proof load and temperature requirements. Importantly, these bolts meet other critical

Regular Nut Eye Bolt Shoulder Nut Eye Bolt Machinery Eye Bolt G-291 G-277 G-279 Important Safety Information— Read and Follow Inspection/Maintenance Safety: † Always inspect eye

Eye Bolts whether Open or Closed Eyes, Forged or Machined, Haydon Bolts has you covered. We have manufactured and provided many different configurations of eye bolts, contact us to see what we can do for you. Diameters: 1/4″ through 1-1/4 Grades: F1554-Grade 55 S1, F1554-Grade 105, A354-BD, A449, A193, 303 SS, 316 SS & Brass Finishes: Plain (black,) Galvanized & []

Learn more about our eye bolts including eye bolt capacity and eye bolt sizes. To learn more call us directly at 800-431-4350 today.

Metric bolts are referenced using "M" sizes, such as the M8 bolt size. The size of a metric bolt is specified using pitch, diameter, and length in millimeters. For example, in M8-1.0*20, the "M" means the Metric thread designation, the digit 8 refers to the Nominal diameter (in millimeters), 1.0 refers to the pitch, and 20 refers to the

Use a spreader bar with regular (non-shoulder) eye bolts to keep the lift angle at 90° to the horizontal. Use eye bolts at a horizontal angle greater than 45°. Sling strength at 45° is 71% of vertical sling capacity. Eye bolt strength at 45° horizontal angle drops down to 30% of vertical lifting capacity. Use a swivel hoist ring for angled

Grade 80 eye bolts and eye nuts are manufactured from high tensile alloy steel and individually magnaflux crack detected after heat treatment. All lifting eyes are proof tested to 2.5 times the working load limit. Always select the correct eye bolt based on its type and capacity for the lift you are conducting.

THE CROSBY GROUP. REGULAR NUT EYE BOLTS. G-291. Recommended for straight line pull. All Bolts Hot Dip galvanized after threading (UNC). Furnished with standard Hot Dip galvanized hex nuts. Forged Steel — Quenched and Tempered. Fatigue rated at 1-1/2 times the Working Load Limit at 20,000 cycles. Shank.