on O-ring drive belts and their application will be found in O-Ring Applications, Section III. 1.2 What is an O-Ring Seal? An O-ring seal is used to prevent the loss of a fluid or gas. The seal assembly consists of an elastomer O-ring and a gland. An O-ring is a circular cross-section ring molded from rubber (Figure 1-1).

These two unique items make simple work of determining the correct O-ring number without measuring them. O-rings up to about 4 inches are measured on the cone, 

The Parker O Ring Sizing Cone For Checking Any Sample O Ring Up to 8" in Diam, to Determine the Nearest Standard Parker Seal 2 Dash Size can be found within the O-Ring

A unique measuring cone and circumference “Pi” tape provide quick and easy o-ring sizing information to determine the nearest standard Parker o-ring size.

71 O-ring sizes acc. to inner diameter 85 ®Parbak Back-up rings 4 O-Ring Guide Parker annin O-Ring Diision Europe Parker manufactures O-rings and spe-cial moulded parts for

O-Ring Gauge Make Work Smart, Telescoping O Ring Sizing Plastic Gauge, Slide Style National Type, for Measuring O Rings Inner Diameter, OD, Thickness Gauge Blue 76 $25.99 $ 25 . 99

Cone for 1/4" to 3" ID ranges comes with a sizing tape to identify large O-rings with a 3 1/8 " to 8" ID. This two-piece measuring system identifies 226 dash numbers. Cone for 6 mm to 69 mm ID ranges identifies the actual O-ring size. Cone for 1/4" to 5 5/8" ID ranges identifies 209 dash numbers.

The Parker O-Ring Handbook has been a standard reference work used by seal designers for decades. 5.4 O-ring measuring cone and measuring tape .

Parker Series 2-XXX O-Ring Sizes (Continued) Parker . Parker Hannifi n Corporation • O-Ring Division 2360 Palumbo Drive, Lexington, KY 40509 Phone: (859) 269-2351 † Fax: (859) 335-5128 www.parkerorings.com Sizes Parker . Sizes Parker Hannifi n Corporation • O-Ring Division

Parker’s unique measuring cone and circumference “Pi” tape provide quick and easy O-ring sizing information to determine the nearest standard Parker O-ring size. Please note: the cone and tape do not measure actual dimensions of a part and cannot be used for pass/fail inspections. Start Shopping.

The main function of Ermeto DIN banjo fittings is to connect different numbers of tubes or hoses. This broad range of DIN fittings is available in steel and in stainless steel.