steel tube fittings of identical sizes. For additional information, see the 316 Stainless Steel. Swagelok Tube Fittings with Advanced Geometry. Back Ferrules 

Pipe Fittings are sized with respect to pipe size. In Nominal pipe size (NPS) & also as a Diameter nominal (DN) · Thicknesses are marked in schedule no. Fittings 

Stainless Tu AN Equivalent All dimensions are in inches unless otherwise noted. AN: Tube Size OD Thread Size Wrench Size-2: 1/8" 5/16"-24: N/A-3: 3/16" 3/8"-24: 1/2"-4: 1/4" 7/16"-20: 9/16"-5: 5/16" 1/2"-20: N/A-6: 3/8" 9/16"-18: 11/16"-8: 1/2" 3/4"-16: 7/8"-10: 5/8" 7/8"-14: 1" -12: 3/4" 1 1/16"-12: 1 1/4"-16: 1" 1 5/16"-12: 1 1/2" -20: 1 1/4" 1 5/8"-12: 1 7/8" -24: 1 1/2" 1 7/8"-12: N/A-28: 1 3/4"

This standard specifies dimensions for stud ends and tapped holes with metric fine pitch thread and pipe thread for use with compression fittings, valves and 

Pipe Elbow Dimensions - Long & Short Radius Elbow Dimensions. Pipe Elbow Dimensions - Long & Short Radius Elbow Dimensions in mm Pipe Elbow dimensions are covered in ASME B16.9. Refer to the table given below for the dimension of the elbow size 1/2″ to 48″. Pipe Fittings Dimensions Tolerance as per ASME B16.9

The standards used to check Dimensions of Pipe Fittings For Wrought Product (WP) Dimension is covered in ASME B16.9- which is standard for Factory-made Wrought Butt-welding Fittings for

PFA Tube Fittings. Features: Temperatures from 70 to 400°F (20 to 204°C); Working pressures up to 275 psig (18.9 bar); Sizes from 1/8 to 1/2 in. Download Add To Favorites. Gaugeable

PVC Pipe Sizes & Dimensions Guide (Charts) When it comes to the PVC pipes themselves, there are 3 key metrics: Outer diameter, inside diameter and wall diameter (as in wall thickness). Below are a series of PVC pipe diagrams and dimension charts to help you find the right sizes (or at least get you informed as to the various common sizes

DIN EN 642:1994. Prestressed concrete pressure pipes, cylinder and non-cylinder, including joints, fittings and specific requirement for prestressing steel for pipes. DIN EN 681-1:2003. Elastomeric seals - Materials requirements for pipe joint seals used in water and drainage applications - Part 1: Vulcanized rubber;

The standards used to check Dimensions of Pipe Fittings For Wrought Product (WP) Dimension is covered in ASME B16.9- which is standard for Factory-made Wrought Butt-welding Fittings for

Pipe and Tube Standard Size chart in mm and inches, Pipe and Tube Dimensions and Weight Chart. Pipes and Tubes of high quality are required by chemical industries, steel factories,