Alarm.com Temperature Sensor (ADC-S2000-T-RA) Installation Guide Box Contents: • Temperature Sensor • CR123 Battery • Nail • Double-sided Adhesive Tape Installation For optimal performance install the Temperature Sensor approximately 5 feet above the floor of an interior wall. Avoid installing the Temperature Sensor on an exterior wall

1. Locate the two pin connector with one black wire and one blue + white wire for the 5C260 wiring harness. 2. Cut the 2-PIN connector (Fig.1) on the 5C260 wiring harness. 3. Connect white + blue cable from device to white cable from temperature sensor probe. 4. Connect black cable from device to blue and black cables from the temperature probe.

This manual is available in English on the Web site (www.apc.com). Temperature/Humidity Module. Installation—Accessories. Sensors.

Consider the following mounting location guidelines: Avoid areas subject to excessive vibration, electrical noise, direct sunlight, or the effects of radiant 

2.1 kg (4 lb 10 oz) The following details are common to all UCC controllers: Configured for direct CNC controlled (DCC) CMMs. Processor type: 1.6 GHz Intel Atom. Suitable hand control unit: MCUlite-2*, MCU5-2, MCU W-2. Digital SPA control output. Communications link with PC: Ethernet.

A T280R Remote Temperature Probe may be used to monitor temperature within the range from -40°F to 140°F (-40°C to 60°C) or to monitor temperature in a harsh environment. INSTALLATION Mount the unit on a wall at a convenient viewing height. For accurate temperature sensing at the unit, do not mount the TS300 near any heat or cooling source.

other Xantrex products compatible with this battery temperature sensor. Installing Battery Temperature Sensor To install a BTS: 1. Switch off all devices operating from the battery. 2. Connect the ring terminal on the sensor directly to the negative battery stud, Battery Temperature Sensot Installation Guide Created Date: 3/23/2005 4:41:28

For the transmitter installation, the optimal method, known as direct mounting, is to have the transmitter integrally mounted with the sensor 

Includes an installation section with applicable notes, cautions, warnings and illustrations showing the installation of the sensor.

Installation guide Temperature Sensor: Physical; Color: Black: Height: 0.20 in (0.5 cm) Width: 0.20 in (0.5 cm) Depth: 0.20 in (0.5 cm) Net Weight: 0.31 lb(US) (0.14 kg) Mounting Location: Front Rear: mounting preference: No preference: Mounting Mode: Rack-mounted: Environmental; ambient air temperature for operation:

Before assigning the sensor to a receiver/controller, the device must be exposed to a good light source for a minimum of 2 hours, or install the optionalstart assist battery(not supplied). 1. Remove the sensor from the back plate by pressing in on the tab on the lower edge and pulling away from the back plate. 2.