Taper Lock Bushes are standard conical bushes used as a locking mechanism for fixing pulleys, Standard range from TB 1008 to TB 5050 for holes from 9.0 to 125.0 mm Inch dimensions from 3/8" to 5" TB 6050, TB 7060, TB 8065 and TB 10085 bushings for

Object Moved This document may be found here

Part No# Description Price UOM FG1615‑M12 1615 Bush 12mm Bore 4mm Keyway AU$13.46 Each FG1615‑M14 1615 Bush 14mm Bore 5mm Keyway AU$13.46 Each FG1615‑M16 1615 Bush 16mm Bore 5mm Keyway AU$13.46 Each

Metric Taper Lock Bushes Bore Keyway (W x D) App. Kg 1008 10 4x4 0.14 12 4x4 0.13 14 5x5 0.13 15 5x5 0.13 16 5x5 0.12 17 5x5 0.1 18 6x6 0.12 19 6x6 0.1 20 6x6 0.1 22 6x6 0.1 24 8x7

TAPER-LOCK® BUSHINGS. If catalog number ends in an ‘S’ the part is a steel bushing. If catalog number ends in an ‘SS’ the part is a stainless steel bushing. L – Space required to tighten bushing or loosen to remove hub with puller using short hex key. M – Space required to remove bushing using screws as jackscrews – short hex key

The Fenner® Taper Lock® bush is the most successful shaft fixing in the market place today with a full range of both metric and imperial sizes as well as a 

18 rows · Description. The Taper Lock bush is designed to give rapid assembly and dismantling of the pulley and other transmission equipment with no special tool requirement except

Taper Lock® Four Hole Bush Simple, Universal Solution. Machined to exacting tolerances in cast iron and steel, the Fenner Taper Lock four hole bush has been tried and tested in over 60 million applications. It is the most successful shaft fixing in the market place today with a full range of both metric and imperial sizes as well as a full

The Taper-Lock™ bushing system keeps the sprocket hubs narrow so the length-thru-bore dimension is less than ever before. The left-justified hub design allows shaft mounting close to bearings, keeping the center of load dimension small while preventing issues with high overhung loads. Taper-Lock bushings are split through the flange and

This Ever-Power’s size 3030 taper lock bushing with a torque capacity of 24000 in-lbs is constructed of steel and can be used for installation a taper lock pulley, sheave, or sprocket on a drive shaft. It is flush installed for reduced mounting width and has a split taper for a good clamp to shafts. The bushing is constructed of steel for

Taper Lock Bushes come in a variety of bore sizes, in both metric and imperial. Bush. A. B. D. G. Set Crews. Dia. x Len.