Hydraulic Industry Standard Industry standards set specific require- ments concerning construction type, size, tolerances, burst pressure, and impulse cycles. Available in either braided or spiral constructions. For use with petroleum- based fluids, diesel fuel, hot lubricating oil, air, ethylene glycol anti-freeze, and water. Transportation

Type 'S' & GC / VA hose available in length of 250, 300, 400, 500, 600, 750, 1000, 1250, 1500, 1750, 2000, 2250, 2500, 3000, 4000 & 5000 mm ex-stock. Required length can be made. ACCESSOEIRS All the accessories are available in BSP / METRIC / JIC threads made from Mild Steel, Brass or Stainless Steel materials.

The use of an incompatible hydraulic fluid will deteriorate inner tube rubber W series is high pressure hose which cleared SAE standard specification.

Sumitomo Riko global hydraulic hose meet the requirements of SAE/DIN/ISO/MSHA. Page 2. 2. INNER COVER : OIL RESISTANT SYNTHETIC RUBBER. REINFORCEMENT : STEEL 

hydraulic hose products, couplings and crimping equipment. There is the argument that hoses branded with the same SAE specification are the same and can 

pressurised hydraulic hose assembly with any part of your body, if fluid punctures the skin, even if no pain is felt, a serious emergency exists. REFERENCE SPECIFICATIONS SAE - Society of Automotive Engineers MSHA - U.S. Mine Safety and Health Administration DNV - Det Norske Veritas LOBA - Landesobergamt Nordrhein - Westfallen

6.Do notuse hydraulic hose to with Gates crimpers. tr ansmit high pressure gases. 4. Wear safety glasses. Follow Good Maintenance Practices Select and Install Assemblies Fluid under pressure can With Care 1. Establish a programof cause serious injury. It can be inspection, testing and almost invisible escaping from a 1.

Hose Information—The Government Specification and the Custodian of the Specification should be consulted for infor-mation regarding the use of the hoses. 6. Internal Abrasion—For applications of a highly abrasive nature where the hose makes one or more bends, hose should be rotated 90° periodically to lengthen service life.

Pressure drop in psi (pounds per square inch) per 10 feet of hose (smooth bore) without fittings. Fluid specification: Specific gravity = 0.85; Viscosity = v = 20 centistokes (C.S.), (20 C.S. = 97 S.S.U.) Pressure drop values listed are typical of many petroleum based hydraulic oils at approximately +100ºF (+38ºC).

The following publications form a part of this specification to the extent specified herein. The latest issue of SAE publications shall apply. 2.1.1 SAE 

Hose Structure Recommended Fluids Hose Structure & Reinforcement Operating Temperature INNER COVER : OIL RESISTANT SYNTHETIC RUBBER REINFORCEMENT : STEEL WIRE OUTER COVER : ABRASION AND OZONE RESISTANT SYNTHETIC RUBBER Mineral Hydraulic Oil-40℃ ～ +100℃ 1W/B DIB-1SN I.D. inch mm O.D. Wax.W.P. Min.B.P. Min.B.R. Weight